I ran avantgarde 107db with XA-25 and Nagra Classic Pre (-120db noise floor)
Although AG always played best with tube amps imho.
Once hiss is heard its quite annoying.
A tube change was long due for my Rönt2. It was on original gz34 of russian specs, the base of it had a crack. Sound had gone thin and to put it simple: lacking.
Inspiration and confidence was built up by Savvas work.
A NOS 4-notch double O-getter mullard was sourced + 2x Short base PL36.
I...
Thanks for the replies.
I will pull out the usb microscope and measure VTA.
The loading Pcb sits correctly as it seems.
Can I assume you both consider the SUT on bps fine with 1ohm load on primary?
Hi,
Im trying to set up some for me new gear consisting of:
Feickert Woodpecker
Brinkmann 12.1
Transfiguration Proteus.
Nagra BPS loaded with 100ohm.
I have calibrated with the feickert protractor. And with my loupe it all looks good.
But I have a certain amount of sibilance generally.
Could...
Im contemplating a Gat, but am worried for the highish gain. My speakers have 107db sensitivity.
Anyone know if it’s adjustable - Perhaps as factory modification?
Zanden 3100 preamp uses Lundahls as seen in this Italian review.
https://www.audiopoint.it/wp-content/uploads/2017/11/Zanden-ar387mac-6.pdf
Size and format of the transformers in 3000mk2 screams Lundahl, but one could only guess ??
Very complicated/over-engineered way of solving the motorized function of the Alps RK501.
They start with an entry level motorized alps RK168 (Only used as motor!)
Then over to another DC-motor.
Then finally to the RK501.
Hi!
Anybody here compared Zanden 3100 vs. Zanden 3000(mk1)?
There are obvious advantages to both; as looks for the 3000 and remote for the 3100.
How about sound?
My amps are Lamm ML's.
Thanks.
(Pardon if the question is posted in wrong forum:thread. I am new to WBF)