Based upon what you received with your arm….
Referring to the Pivot to Spindle device…
For my XL- 9 ....I have the cylinder
For my XL-10 inch ....I have the new oblong device
I am aware that with the new XL-12 inch arm the alignment spindle adaptor is the new cube device [not original cylinder cup]
Re Cube…in your experience.....does this adaptor apply to the 10 inch [as well as 9 ..??] **but have also previously had 12” with the cylinder cup …
**Re 10 inch......Cylinder gives correct measurement...cube is measuring to long by about 4mm
i.e.
12 inch….?? Device
10 inch….?? Device
09 inch….?? Device
Am aware we can use a measuring device but am questioning the Graham device….
Have asked Bob…appreciate he is busy……
Referring to the Pivot to Spindle device…
For my XL- 9 ....I have the cylinder
For my XL-10 inch ....I have the new oblong device
I am aware that with the new XL-12 inch arm the alignment spindle adaptor is the new cube device [not original cylinder cup]
Re Cube…in your experience.....does this adaptor apply to the 10 inch [as well as 9 ..??] **but have also previously had 12” with the cylinder cup …
**Re 10 inch......Cylinder gives correct measurement...cube is measuring to long by about 4mm
i.e.
12 inch….?? Device
10 inch….?? Device
09 inch….?? Device
Am aware we can use a measuring device but am questioning the Graham device….
Have asked Bob…appreciate he is busy……
Last edited: