Do not want to clutter Ron's thread- but I had a couple of folks reach out- so here it is.
I used a similar HSS ( hollow structural steel) stand that was originally purposed for the Goldmund Reference- What happened to that very expensive heavy table is a mystery. However, I ended up with the stand and the top plate which is 2" thick brass it is massively heavy and inert. I layered a custom size segue mat on top for isolation and then with the HRS 3x . This HRS has the split top to isolate the motor from the table section. I do not believe HRS does this anymore. I added finite elemente ceraball feet for leveling and further isolation.
Lastly, I built a drawer for anlog junk as part of the stand.
.
I used a similar HSS ( hollow structural steel) stand that was originally purposed for the Goldmund Reference- What happened to that very expensive heavy table is a mystery. However, I ended up with the stand and the top plate which is 2" thick brass it is massively heavy and inert. I layered a custom size segue mat on top for isolation and then with the HRS 3x . This HRS has the split top to isolate the motor from the table section. I do not believe HRS does this anymore. I added finite elemente ceraball feet for leveling and further isolation.
Lastly, I built a drawer for anlog junk as part of the stand.
.