Recently I added a Phantom Supreme to my Raven Two. The Phantom replaced my Graham 2.2 as the primary arm, and the G-2.2 is now on the back side. Initally, the Raven-2 and Graham 2.2 had a similar issue where the arm height forced me to exist in the lower, l.0-2.0 VTA range. The Phantom is even worse in this regard. Even at 1.0 the buble level is past the right red marking and I am unable to level the gauge/cartridge. Though I am complete 2-turns of the VTA dial above this, (final setting yet to be determined) I find it a bit disconcerting that I can't at least start from a "level" position since my final setting may be lower than obtainable.
So, I see three choices, a modified armboard or armboard pillar, both potentially costly. The third option is to add an insert between the Benz and the headshell allowing me to raise the VTA and gain a greater range of adjustment.
Any other Raven-1 or 2 owners share a similar tale of woe? Any suggestions for a spacer or solution?
On the bright side I'm kicking myself for waiting so long to add the Phantom! A huge improvement! WOW!
So, I see three choices, a modified armboard or armboard pillar, both potentially costly. The third option is to add an insert between the Benz and the headshell allowing me to raise the VTA and gain a greater range of adjustment.
Any other Raven-1 or 2 owners share a similar tale of woe? Any suggestions for a spacer or solution?
On the bright side I'm kicking myself for waiting so long to add the Phantom! A huge improvement! WOW!