my custom room:
21x15x10. Minimal modes
hardwood floor over trusses (doubled at 1/3 & 2/3 length)
tongue & groove pine walls & ceiling
6 dedicated circuits
tube traps in all 4 corners and behind speakers
wall traps at all first reflection points and opposite walls behind speakers
And this from the MSB Diamond DAC V Manual
Clock Interface
After years of experimenting with inputting and outputting clocks we now strongly recommend not doing this. A low jitter clock must be physically close to the DACs. There is no lower jitter clock than the MSB clocks, and even if there...
So if the gigafoil and a good psu just prior to MSB renderer are providing a pure digital feed, what would the sotm switch be doing to make it sound better?
Thanks for the many replies and wisdom.
Excuse my ignorance... my question comes largely from that source I suspect.
Anyway, I’m looking for new amps to replace current BAT bridged VK55se used to drive my new Giya G2s. Was talking to MSB who touted their amps as not using feedback as though...