I have a Cremona centre with a blown mid which looks like the same unit as the ScanSpeak 12m https://www.falconacoustics.co.uk/downloads/Scanspeak/12m-4631g00.pdf
The crossover measure 0.7 Ohms I just wanted to make sure it's okay to add another driver. SF are quoting me for a replacement not sure if the SF driver is any different at all ?
Speaker works but missing mid, I think I blew it with bad timing of turning on the power amp just as the pre-amp came on, it's not the coil its the connection where the flexible braid joines the thin coil lead
Any advice appreciated. Plot about three weeks ago in green, blue after the driver failed (Microphone in similar position)
The crossover measure 0.7 Ohms I just wanted to make sure it's okay to add another driver. SF are quoting me for a replacement not sure if the SF driver is any different at all ?
Speaker works but missing mid, I think I blew it with bad timing of turning on the power amp just as the pre-amp came on, it's not the coil its the connection where the flexible braid joines the thin coil lead
Any advice appreciated. Plot about three weeks ago in green, blue after the driver failed (Microphone in similar position)
