Brinkman Ront II problem.

[neac1976]

Hello everyone.
I have owned the Brinkman Spyder, with three tonearms for more than eight years and it has performed flawlessly. I have continued to use The Ront Supply with no problems until last week.
1. The Ront will no longer power the motor...but the fuse appears to fine.
2. The motor lights will not light up.
3. When I look at the three tubes, they are all illuminated but again, the motor does not turn.
4. I can still use the s.s. power supply with no problem at all.
Does anyone have any suggestions as to what the problem is or how to fix it?
Thank you guys,
Mark

 

[Argonaut]

I am sorry to hear of your problem , Unless another member comes forward with some hands on practice advice I would recommend contacting the dealer who supplied your Brinkmann system if feasible ? As altho your Ront II is obviously out of its warranty cover they may well offer you some assistance , failing that I would contact Brinkmann directly and discuss the problem with them .

A couple of points off the top of my head , Altho the manual ‘lightly’ covers a unit entering into a ‘stand by state ’ and from recollection references the DD models , your unit might have become locked into such a condition ? Particularly were there to be a compost failure to that sub circuit.

Do you have a spare 5AR4 available ?

I expect that you have double checked the umbilical cable and connection at the Ront end ( as you have already trouble shot the turntable connection with your SS PSU ) Is it seated correctly within the socket .

 

[exupgh12]

It sounds like an issue with the motor drive circuit or voltage regulation in the Ront. Try these steps:

1. Check Connections – Ensure all cables are securely connected.

2. Measure Output Voltage – Use a multimeter to check if the Ront supplies power.

3. Inspect Tubes – Even if they glow, try swapping them.

4. Look for Damage – Open the unit (if comfortable) and check for burnt components.

5. Contact Brinkmann – Their support team may offer a fix or service.

Since the solid-state PSU works, the fault is isolated to the Ront. A technician may be needed.

 

[audioguy3107]

Hi Mark, this problem happened to me about two months ago, although I'm not entirely sure it's the same problem. Double check the middle tube, its that one lit up as normal? Mine appeared to be fine but when I took it to the dealer, they said the tube was bad.....said it was a known issue with that tube which is why Brinkmann designed a new tube for the RONT III. They replaced it with the newer one and everything has been fine since.

- Buck

 

[Argonaut]

Double check the middle tube, its that one lit up as normal? Mine appeared to be fine but when I took it to the dealer, they said the tube was bad.....said it was a known issue with that tube which is why Brinkmann designed a new tube for the RONT III. T

Yup … hence my hoping that the OP has a spare 5AR4 in the house , with a touch of luck he might be up and running Tout de suite .