Nyal and I were doing some measurments today and we got stumped with my RME hdspe aio soundcard. I have a tascam I can measure with so we still took some good sweeps but I would prefer the setup to be as synchronous as possible.
We had jriver setup in WASAPI loopback so I can send REW's sweep out to my DAC over the RME's AES out. That part works great. I can hear the sweep and see it in the RME mixer. But when I set the RME line in on the REW input I can only see the mic signal in the RME mixer, so I know its not a mic, mic preamp or cabling problem. The problem is that REW doesn't see the input signal. We also tried routing the input through default windows recording device to "line in" which is the RME's stereo input and using the direct output in jriver instead of ASIO. That didn't work either. Anyone have any Iidea what we are doing wrong? Mojave?
We had jriver setup in WASAPI loopback so I can send REW's sweep out to my DAC over the RME's AES out. That part works great. I can hear the sweep and see it in the RME mixer. But when I set the RME line in on the REW input I can only see the mic signal in the RME mixer, so I know its not a mic, mic preamp or cabling problem. The problem is that REW doesn't see the input signal. We also tried routing the input through default windows recording device to "line in" which is the RME's stereo input and using the direct output in jriver instead of ASIO. That didn't work either. Anyone have any Iidea what we are doing wrong? Mojave?
Last edited: